How To Install cutter on Ubuntu 20.04
Introduction
In this tutorial we learn how to install cutter
on Ubuntu 20.04.
What is cutter
cutter is:
Cutter will send packets to both ends of a TCP/IP connection to close the connection. It is designed to be used on a Linux router to disconnect unwanted connections.
Cutter can close all connections to or from a specified ip-address or ip-address/port pair, allowing, as example, close the specific service of a computer. It also can close the connections between two ip-address that use a specific port to deny a certain service to client. Other possibility is close a specific connection from ip-address/port to ip-address/port.
Cutter is not a firewall, but is part of a larger Linux firewall project.
Cutter 1.04 should be considered EXPERIMENTAL.
There are three methods to install cutter
on Ubuntu 20.04. We can use apt-get
, apt
and aptitude
. In the following sections we will describe each method. You can choose one of them.
Install cutter Using apt-get
Update apt database with apt-get
using the following command.
sudo apt-get update
After updating apt database, We can install cutter
using apt-get
by running the following command:
sudo apt-get -y install cutter
Install cutter Using apt
Update apt database with apt
using the following command.
sudo apt update
After updating apt database, We can install cutter
using apt
by running the following command:
sudo apt -y install cutter
Install cutter Using aptitude
If you want to follow this method, you might need to install aptitude first since aptitude is usually not installed by default on Ubuntu. Update apt database with aptitude
using the following command.
sudo aptitude update
After updating apt database, We can install cutter
using aptitude
by running the following command:
sudo aptitude -y install cutter
How To Uninstall cutter on Ubuntu 20.04
To uninstall only the cutter
package we can use the following command:
sudo apt-get remove cutter
Uninstall cutter And Its Dependencies
To uninstall cutter
and its dependencies that are no longer needed by Ubuntu 20.04, we can use the command below:
sudo apt-get -y autoremove cutter
Remove cutter Configurations and Data
To remove cutter
configuration and data from Ubuntu 20.04 we can use the following command:
sudo apt-get -y purge cutter
Remove cutter configuration, data, and all of its dependencies
We can use the following command to remove cutter
configurations, data and all of its dependencies, we can use the following command:
sudo apt-get -y autoremove --purge cutter
References
Summary
In this tutorial we learn how to install cutter
package on Ubuntu 20.04 using different package management tools: apt
, apt-get
and aptitude
.